Reference Guide

Command Mode CONFIGURATION
Usage Information
• Each breakout interface operates at the congured speed; for example, 10G, 25G, or 50G.
• The no interface breakout node/slot/port command resets a port to its default speed — 40G or
100G.
• To congure breakout interfaces on a unied port, use the mode {Eth | FC} command in the Port-Group
conguration mode.
Example
OS10(config)# interface breakout 1/1/41 map 10g-4x
Supported Releases 10.2.2E or later
interface ethernet
Congures a physical Ethernet interface.
Syntax
interface ethernet node/slot/port:subport
Parameters node/slot/port:subport — Enter the Ethernet interface information.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the interface.
Example
OS10(config)# interface ethernet 1/1/10:1
OS10(conf-if-eth1/1/10:1)#
Supported Releases 10.2.0E or later
interface loopback
Congures a loopback interface.
Syntax
interface loopback id
Parameters id — Enter the loopback interface ID number (0 to 16383).
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the loopback interface.
Example
OS10(config)# interface loopback 100
OS10(conf-if-lo-100)#
Supported Releases 10.2.0E or later
interface mgmt
Congures the Management port.
Syntax
interface mgmt node/slot/port
102 Interfaces