Reference Guide

Command Mode INTERFACE
Usage Information Attach only one network policy for per interface.
Example
OS10(conf-if-eth1/1/5)# lldp med network-policy add 1
Supported Release 10.2.0E or later
lldp med tlv-select
Congures the LLDP-MED TLV type to transmit or receive.
Syntax
lldp med tlv-select {network—policy | inventory}
Parameters
• network-policy — Enable or disable the port description TLV.
• inventory — Enable or disable the system TLV.
Default Enabled
Command Mode INTERFACE
Usage Information None
Example
OS10(conf-if-eth1/1/3)# lldp med tlv-select network-policy
Supported Releases 10.2.0E or later
lldp receive
Enables or disables the LLDP packet reception on a specic interface.
Syntax
lldp receive
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information Enable LLDP globally on the system before using the lldp receive command. The no version of this command
disables the reception of LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp receive
Supported Releases 10.2.0E or later
lldp reinit
Congures the delay time (in seconds) for LLDP to initialize on any interface.
Syntax
lldp reinit seconds
Parameters seconds — Enter the delay timer value in seconds (1 to 10).
Default 2 seconds
Command Mode CONFIGURATION
182 Layer 2