Reference Guide

• any — (Optional) Set routes which are subject to the lter.
– protocol-number — (Optional) MAC protocol number identied in the header, from 600 to .
– capture — (Optional) Capture packets the lter processes.
– cos — (Optional) CoS value, from 0 to 7.
– count — (Optional) Count packets the lter processes.
– vlan — (Optional) VLAN number, from 1 to 4093.
Default Disabled
Command Mode MAC-ACL
Usage Information OS10 cannot count both packets and bytes; when you use the count byte options, only bytes increment. The
no version of this command removes the lter.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# deny any any cos 7
OS10(conf-mac-acl)# deny any any vlan 2
Supported Releases 10.2.0E or later
deny icmp
Congures a lter to drop all or specic internet control message protocol (ICMP) messages.
Syntax
deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [[A.B.C.D | A.B.C.D/x |
any | host ip-address] [capture | count [byte] | dscp value | fragment]
Parameters
• A.B.C.D — Enter the IP address in hexadecimal format separated by colons.
• A.B.C.D/x — Enter the number of bits to match to the IP address.
• any — (Optional) Set all routes subject to the lter.
– capture — (Optional) Capture packets the lter processes.
– count — (Optional) Count packets the lter processes.
– byte — (Optional) Count bytes the lter processes.
– dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IP address to use a host address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information OS10 cannot count both packets and bytes; when you use the count byte options, only bytes increment. The
no version of this command removes the lter.
Example
OS10(config)# ip access-list egress
OS10(conf-ipv4-acl)# deny icmp any any capture session 1
Supported Releases 10.2.0E or later
496 Access Control Lists