Users Guide

225.1.0.2 vlan2001 IGMPv2-Compat
00:01:36
Member-ports :ethernet1/1/21,ethernet1/1/22
<<Output_truncated>>
VLT multicast routing commands
multicast peer-routing-timeout
Configures the time duration for a VLT node to retain synchronized multicast routes if there is a VLT peer node failure.
Syntax
multicast peer-routing-timeout value
Parameters value—Enter the timeout value in seconds, from 1 to 1200.
Default 300 s
Command Mode VLT-DOMAIN
Usage
Information
If one of the VLT peer nodes goes down, the multicast peer-routing timer starts. When the multicast
peer-routing timer expires, the system removes any stale routes that were retained at the time the peer
went down, but were not converged. The routes that are not locally learned and the routes that are not
resynchronized from the peer, or both, are removed.
NOTE: Dell Technologies recommends that you configure the same timeout value on both the VLT
peer nodes.
The no form of this command resets the multicast peer-routing timer value to its default value of 300 s.
Example
OS10(config)# vlt-domain 255
OS10(conf-vlt-255)# multicast peer-routing-timeout 1200
Supported
Releases
10.5.2.0 or later
show vlt inconsistency ip mcache
Displays information about mismatched IIF routes between the local and peer VLT nodes.
Syntax
show vlt inconsistency ip mcache [vrf vrf-name]
Parameters vrf vrf-name—(Optional) Enter the keyword then the name of the VRF to display information about
mismatched IIF routes corresponding to that non-default VRF.
Default None
Command Mode EXEC
Usage
Information
None
Example
OS10# show vlt inconsistency ip mcache
Spanned Multicast routing IIF inconsistency:
Multicast Route Local IIF Peer IIF
(22.22.22.200, 225.1.1.2) Vlan 5 Vlan6
(*, 225.1.1.2) Vlan 15 ethernet 1/1/1
Supported
Releases
10.5.0 or later
Multicast 1133