Users Guide
Parameters
● A::B — Enter the IPv6 address in hexadecimal format separated by colons.
● A::B/x — Enter the number of bits that must match the IPv6 address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
NOTE: The control-plane ACL supports only the eq operator.
● host ipv6-address — (Optional) Enter the keyword and the IPv6 address to use a host address
only.
● ack — (Optional) Set the bit as acknowledgement.
● fin — (Optional) Set the bit as finish—no more data from sender.
● psh — (Optional) Set the bit as push.
● rst — (Optional) Set the bit as reset.
● syn — (Optional) Set the bit as synchronize.
● urg — (Optional) Set the bit set as urgent.
● capture — (Optional) Capture packets the filter processes.
● count — (Optional) Count packets the filter processes.
● byte — (Optional) Count bytes the filter processes.
● dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
● fragment — (Optional) Use ACLs to control packet fragments.
● log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
● operator — (Optional) Enter a logical operator to match the packets on the specified port number.
The following options are available:
○ eq — Equal to
○ gt — Greater than
○ lt — Lesser than
○ neq — Not equal to
○ range — Range of ports, including the specified port numbers.
Default
Not configured
Command Mode IPV6-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(conf-ipv6-acl)# permit udp any any capture session 1 count
Supported
Releases
10.2.0E or later
remark
Specifies an ACL entry description.
Syntax
remark description
Parameters description — Enter a description. A maximum of 80 charaters.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
Configure up to 16777214 remarks for a given IPv4, IPv6, or MAC. The no version of the command
removes the ACL entry description.
Supported
Releases
10.2.0E or later
1500 Access Control Lists