Users Guide
Use this command if there are traffic convergence issues.
Example
OS10# show vlt-mac-inconsistency
Checking Vlan 228 .. Found 7 inconsistencies .. Progress 100%
VLAN 128
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 1
----------
MAC 00:a0:c9:00:00:18 is missing from Node(s) 2
MAC 00:a0:c9:00:00:20 is missing from Node(s) 2
VLAN 131
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 132
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 135
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 137
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
Run "show vlt mismatch ..." commands to identify configuration issues
Supported
Releases
10.2.0E or later
show vlt mismatch
Displays mismatches in a VLT domain configuration.
Syntax
show vlt id mismatch [dhcp-snooping | peer-routing | vlan | vlt-vlan vlt-port-
id | virtual-network | private-vlan {mapping | port-mode | vlan-mode} |
multicast-snooping | ra-guard | vlan-anycast| dhcp-relay]
Parameters
● id — Enter the VLT domain ID, from 1 to 255.
● dhcp-snooping — Display mismatches in a DHCP snooping configuration in a VLT domain.
● peer-routing — Display mismatches in the peer-routing configuration.
● vlan — Display mismatches in a VLAN configuration in the VLT domain.
● vlt-vlan vlt-port-id — Display mismatches in the VLT port configuration, from 1 to 4095.
● virtual-network — Display mismatches in virtual network configurations between VLT peers.
● private-vlan — Displays mismatches in private VLAN mapping, port mode, or VLAN mode.
● multicast-snooping — Displays mismatches in IGMP and MLD snooping configuration.
● ra-guard — Displays mismatches in IPv6 RA guard configuration.
● vlan-anycast—Display mismatches in VLAN anycast IP configuration between VLT peers.
● dhcp-relay — Displays the mismatch (if any) between the VLT peers for DHCP relay options
configuration on global level and VLANs spanned across the VLT peers.
Default Not configured
Command Mode EXEC
Usage
Information
The * in the mismatch output indicates a local node entry.
The show vlt mismatch dhcp-relay command displays the mismatch in the Global ip dhcp-relay
information-option command.
The show vlt mismatch dhcp-relay command displays the presence or absence of Interface level ip
dhcp-relay information-option configurations.
Example (no
mismatch)
OS10# show vlt 1 mismatch
Peer-routing mismatch:
Virtual Link Trunking 1657