Users Guide

Configure polling interval for Ethernet interface
counters
OS10 caches the interface counters every 15 s. The interface statistics include the number of packets that are sent or received
through an interface. You can change this polling interval for Ethernet interface counters from 1 s to 15 s.
To configure the polling interval for Ethernet interface counters, from the CONFIGURATION mode, enter:
OS10(config)# stats-monitor stat-type ethernet polling-interval interval-value
The interval-value can range from 1 s to 15 s.
Interface commands
channel-group
Assigns an interface to a port-channel group.
Syntax
channel-group channel-number mode {active | on | passive}
Parameters
● channel-number — Enter a port-channel number, from 1 to 128.
● mode — Sets LACP Actor mode.
● active — Sets Channeling mode to Active.
● on — Sets Channeling mode to static.
● passive — Sets Channeling mode to passive.
Default Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default, and unassigns the interface from the
port-channel group.
Example
OS10(config)# interface ethernet 1/1/2:1
OS10(conf-if-eth1/1/2:1)# channel-group 20 mode active
Supported
Releases
10.3.0E or later
default interface
Resets an Ethernet or Fibre Channel interface to its default settings.
Syntax
default interface interface-type
Parameters interface-type — Enter the interface type:
● ethernet node/slot/port[:subport] — Resets an Ethernet interface to its default settings.
● fibrechannel node/slot/port[:subport] — Resets a Fibre Channel interface to its default
settings.
● range ethernet node/slot/port:[subport]-node/slot/port[:subport] — Resets a
range of Ethernet interfaces to their default settings.
Default Not configured
Command mode CONFIGURATION
Usage
information
To remove the configuration from an Ethernet or Fibre Channel interface and reset the interface to its
default settings, use the default interface command. By default:
394 Interfaces