Users Guide

scale-profile vlan
Configures the L2 VLAN scale profile on a switch.
Syntax
scale-profile vlan
Parameters None
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
Use the VLAN scale profile when you scale the number of VLANs so that the switch consumes less
memory. Enable the scale profile before you configure VLANs on the switch. The scale profile globally
applies L2 mode on all VLANs you create and disables L3 transmission. The no version of the command
disables L2 VLAN scaling. To enable L3 routing traffic on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported
Releases
10.4.0E(X2) or later
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
● phy-eth node/slot/port[:subport] — Display information about physical ports connected to
the interface.
● status — Display interface status.
● ethernet node/slot/port[:subport] — Display Ethernet interface information.
● loopback id — Display Loopback IDs, from 0 to 16383.
● mgmt node/slot/port — Display Management interface information.
● null — Display null interface information.
● port-channel id-number — Display port channel interface IDs, from 1 to 128.
● vlan vlan-id — Display the VLAN interface number, from 1 to 4093.
Default Not configured
Command Mode EXEC
Usage
Information
Use the do show interface command to view interface information from other command modes.
Example
OS10# show interface
Ethernet 1/1/2 is up, line protocol is up
Hardware is Dell EMC Eth, address is 00:0c:29:54:c8:57
Current address is 00:0c:29:54:c8:57
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR 1.0M
Wavelength is 64
Receive power reading is 0.0
Interface index is 17305094
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Enabled
Link local IPv6 address: fe80::20c:29ff:fe54:c857/64
Global IPv6 address: 2::1/64
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 40G, Auto-Negotiation on
FEC is auto, Current FEC is off
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 00:40:14
408 Interfaces