Users Guide

feature fc
Enables the multiswitch feature.
Syntax
feature fc [domain-id domain-id-val | npg | fip-snooping [with-cvl] |
multi-switch]
Parameters
● with-cvl—To enable CVL.
● domain-id—Enter the domain ID of the E_Port.
● domain-id-val—Valid values are from 1 to 239.
Defaults Disabled
Command Mode GLOBAL CONFIGURATION
Usage
Information
● Use the multiswitch option to support the multiswitch fabric mode.
● Delete multiswitch configurations when disabling a feature.
● You can disable the multiswitch mode only if you delete the related configurations.
● The no form of this command deletes the configuration.
Example
OS10(config)# feature fc multi-switch
Supported
Releases
10.5.1.0 or later
fspf cost
Configures the FSPF cost value for every interface.
Syntax
fspf cost cost-val
Parameters
cost-val—Valid values are from 1 to 65535.
Defaults FSPF cost for the following is:
● 8G-125
● 16G-62
● 32G-31
Command Mode Fibre Channel INTERFACE
Usage
Information
● The configurations are supported only in the multiswitch mode.
● This command configures the cost of the selected interface. Also, it configures the same cost value
on both ends of the link.
● Different cost values lead to repeat the request repeatedly or even indefinitely.
● The no version of this command resets the command to default value, for the interface speed.
Example
OS10(config-if-fc-1/1/1)#fspf cost 90
Supported
Releases
10.5.1.0 or later
fspf dead-interval
Configures the FSPF dead Interval value for every interface.
Syntax
fspf dead-interval timeout-val
Parameters
timeout-val—Valid values are from 1 to 65535.
Defaults 80 s
Command Mode Fiber channel INTERFACE
Fibre Channel 451