Users Guide

fc port-mode F
Configures port mode on Fibre Channel interfaces.
Syntax
fc port-mode F
Parameters None
Defaults N_Port
Command Mode Fibre Channel INTERFACE
Usage
Information
Configure the port mode when the port is in Shut mode and when NPG mode is enabled. The no version
of this command returns the port mode to default.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# fc port-mode F
Supported
Releases
10.4.1.0 or later
feature fc npg
Enables the NPG mode globally.
Syntax
feature fc npg
Parameters None
Defaults Disabled
Command Mode CONFIGURATION
Usage
Information
You can enable only one of the following at a time: F_Port, NPG, or FSB. The no version of this command
disables NPG mode.
Example
OS10(config)# feature fc npg
Supported
Releases
10.4.0E(R1) or later
show npg devices
Displays the NPG devices connected to the switch.
Syntax
show npg devices [brief]
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
Use the brief option to display minimum details.
Example
OS10# show npg devices
Enode[0]:
Enode MAC :d4:ae:52:1a:ee:54
Enode Interface: port-channel10(Eth 1/1/9)
FCF MAC :14:18:77:20:7c:e3
Fabric Interface :Fc 1/1/25
FCoE Vlan :1001
Vfabric Id :10
ENode WWPN :20:01:d4:ae:52:1a:ee:54
Fibre Channel 497