Users Guide

Switch Config Parameters
==========================================
Domain ID 4
==========================================
Switch Zoning Parameters
==========================================
Default Zone Mode: Deny
Active ZoneSet: zoneset5
=========================================
Members
fibrechannel1/1/25
port-channel10(Eth 1/1/9)
Supported
Releases
10.3.1E or later
vfabric
Configures a vfabric.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
Enable the F_Port or NPG feature before configuring a vfabric. You can configure only one vfabric in
F_Port mode. The vfabric becomes active only when you configure the vfabric with a valid VLAN and FC
map. Do not use spanned VLAN as vfabric VLAN.
The no version of this command removes the vfabric. You can remove a vfabric only when it is not
applied on any interface.
Example
OS10(config)# vfabric 100
Supported
Releases
10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an Ethernet or FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes the vfabric from the interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# vfabric 200
Supported
Releases
10.3.1E or later
508 Fibre Channel