Users Guide

fip-snooping enable
Enables FIP snooping on a specified VLAN.
Syntax
fip-snooping enable
Parameters None
Defaults Disabled
Command Mode VLAN INTERFACE
Usage
Information
Enable FIP snooping on a VLAN only after enabling the FIP snooping feature globally using the feature
fip-snooping command. OS10 supports FIP snooping on a maximum of 12 VLANs. The no version of
this command disables FIP snooping on the VLAN.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping enable
Supported
Releases
10.4.0E(R1) or later
fip-snooping fc-map
Configures the FC map value for a specific VLAN.
Syntax
fip-snooping fc-map fc-map
Parameters fc-map — Enter the FC map ID, from 0xefc00 to 0xefcff.
Defaults Not configured
Command Mode VLAN INTERFACE
Usage
Information
The no version of this command disables the FC map configuration.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
Supported
Releases
10.4.0E(R1) or later
fip-snooping port-mode
Sets FIP snooping port mode for interfaces.
Syntax
fip-snooping port-mode {enode | enode-transit | fcf | fcf-transit}
Parameters
enode | enode-transit | fcf | fcf-transit—Enter the keyword to set FIP snooping port
mode.
Defaults ENode port mode
Command Mode INTERFACE
Usage
Information
OS10 supports this configuration only on a switch running FSB mode, and on Ethernet and port-channel
interfaces. You cannot configure FIP snooping port mode on a port channel member.
Use this command to change the port mode. By default, the port mode of an interface is set to ENode.
Configure the port mode only after you enable FIP snooping. Before you disable FIP snooping, reset the
port mode to its default value, ENode.
510 Fibre Channel