Users Guide
lldp tlv-select basic-tlv
Enables or disables TLV attributes to transmit and receive LLDP packets.
Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-
description | system-capabilities | management-address [ipv4 | ipv6]}
Parameters
● port-description — Enable or disable the port description TLV.
● system-name — Enable or disable the system TLV.
● system-description — Enable or disable the system description TLV.
● system-capabilities — Enable or disable the system capabilities TLV.
● management-address — Enable or disable the management address TLV (IPv4 and IPv6).
● management-address ipv4 - Enable or disable only the IPv4 management address TLV.
● management-address ipv6 - Enable or disable only the IPv6 management address TLV.
Default Enabled
Command Mode INTERFACE
Usage
Information
The no form of the command disables TLV attribute transmission and reception in LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
Supported
Releases
10.2.0E or later
lldp management-addr-tlv virtual-ip
Enables VLT peers to send the elected virtual IP address in the management address TLV.
Syntax
lldp management-addr-tlv {ipv4 | ipv6} virtual-ip
Parameters
● ipv4 — Select ipv4 for the VLT peers to send the virtual IPv4 address in the management TLV.
● ipv6 — Select ipv6 for the VLT peers to send the virtual IPv6 address in the management TLV.
Default Disabled
Command Mode
● CONFIGURATION
● INTERFACE
Usage
Information
When enabled in CONFIGURATION mode, the system advertises the elected IP address in the
management address TLV of all the interfaces.
When enabled in INTERFACE mode, the system advertises the elected IP address in the management
address TLV of that specific interface.
The no version of this command resets to default. By default, the system transmits the local management
IP address.
Example
OS10(config)# lldp management-addr-tlv ipv4 virtual-ip
OS10(conf-if-eth1/1/3)# lldp management-addr-tlv ipv6 virtual-ip
Supported
Releases
10.5.0 or later
lldp tlv-select dot1tlv
Enables or disables the dot.1 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot1tlv { port-vlan-id | link-aggregation | vlan-name}
Parameters
● port-vlan-id — Enter the port VLAN ID.
Layer 2 583