Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4112F-ON/S4112T-ON
641642643644645646647648649650
Internet address is 10.1.1.1/24
Mode of IPv4 Address Assignment: MANUAL
Interface IPv6 oper status: Enabled
Link local IPv6 address: fe00::0000:0000:0000:10c0/64
Global IPv6 address: 2001:200:1:1::5/64
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 10G
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 3 weeks 5 days 13:46:23
Queuing strategy: fifo
Input statistics:
995446 packets, 342789180 octets
Output statistics:
1368934 packets, 369275748 octets
Time since last interface status change: 3 weeks 5 days 13:45:57
Vlan 200 is up, line protocol is down
Address is 00:00:00:00:00:c9, Current address is 00:00:00:00:10:c9
Interface index is 69209064
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Enabled
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 0
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 15:48:51
Queuing strategy: fifo
Input statistics:
0 packets, 0 octets
Output statistics:
0 packets, 0 octets
Time since last interface status change: 15:48:51
Vlan 320 is up, line protocol is down
Address is 00:00:00:00:00:c9, Current address is 00:00:00:00:10:c9
Interface index is 69209184
Internet address is 20.2.11.1/24
Mode of IPv4 Address Assignment: MANUAL
Interface IPv6 oper status: Enabled
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 0
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 15:47:04
Queuing strategy: fifo
Input statistics:
0 packets, 0 octets
Output statistics:
0 packets, 0 octets
Time since last interface status change: 15:47:04
Access mode
An access port is an untagged member of only one VLAN. Configure a port in Access mode and configure which VLAN carries
the traffic for that interface. If you do not configure the VLAN for a port in Access mode, or an access port, the interface
carries traffic for VLAN 1, the default VLAN.
Change the access port membership in a VLAN by specifying the new VLAN. You must create the VLAN before you can assign
the port in Access mode to that VLAN. Use the no switchport access vlan command to reset to default VLAN.
1. Configure a port in CONFIGURATION mode.
interface ethernet node/slot/port[:subport]
2. Set the interface to Switchport mode as access in INTERFACE mode.
switchport mode access
3. Enter the VLAN number for the untagged port in INTERFACE mode.
switchport access vlan vlan-id
Layer 2
643