Users Guide

Example
OS10# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring
VLANs,
@ - Attached to Virtual Network, P - Primary, C - Community, I -
Isolated
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 Active A Eth1/1/15
A Po100
2101 Active T Eth1/1/1,1/1/3
T Po100
2102 Active T Eth1/1/1,1/1/3
Supported
Releases
10.2.0E or later
show vlt mismatch
Displays the anycast IP configuration mismatch between VLT peers.
Syntax
show vlt domain-id mismatch [vlan-anycast]
Parameters domain-id—Enter the VLT domain ID.
Command Mode EXEC
Usage
Information
Use this command to identify anycast IPv4 or IPv6 configuration mismatch on VLT nodes for VLAN
interfaces.
Example
OS10# show vlt 1 mismatch vlan-anycast
VLAN anycast ip Mismatch:
VLAN: 2000
VLT Unit ID Anycast-IPs
----------------------------------------------------
* 1 10::100, 10.10.10.10
2 100::100, 100.101.101.100
VLAN: 3000
VLT Unit ID Anycast-IPs
----------------------------------------------------
* 1 100.100.101.100
2 Not configured
VLAN: 4000
VLT Unit ID Anycast-IPs
----------------------------------------------------
* 1 Not configured
2 10.10.10.15
Supported
Releases
10.5.2.0 or later
Private VLANs
Private VLANs (PVLANs) enhance the security of Dell EMC SmartFabric OS10 by providing L2 isolation between ports within
the same virtual local area network (VLAN). A PVLAN partitions a traditional VLAN in to subdomains identified by primary and
secondary VLAN pairs. PVLANs block all traffic to isolated ports except for traffic from promiscuous ports. Traffic received
from an isolated port is forwarded only to promiscuous or trunk ports.
662
Layer 2