Users Guide

end
Returns to EXEC mode from any other command mode.
Syntax
end
Parameters None
Default Not configured
Command Mode All
Usage
Information
Use the end command to return to EXEC mode to verify currently configured settings with show
commands.
Example
OS10(config)# end
OS10#
Supported
Releases
10.2.0E or later
exit
Returns to the next higher command mode.
Syntax
exit
Parameters None
Default Not configured
Command Mode All
Usage
Information
None
Example
OS10(conf-if-eth1/1/1)# exit
OS10(config)#
Supported
Releases
10.2.0E or later
hostname
Sets the system host name.
Syntax
hostname name
Parameters name — Enter the host name of the switch, a maximum of 64 characters.
Default OS10
Command Mode CONFIGURATION
Usage
Information
The host name is used in the OS10 command-line prompt.
The no version of this command resets the host name to OS10.
Example
OS10(config)# hostname R1
R1(config)#
Supported
Releases
10.3.0E or later
CLI Basics 81