Users Guide

ip ospf transmit-delay
Sets the estimated time required to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
Parameters seconds — Set the time in seconds required to send a link-state update, from 1 to 3600.
Default 1 second
Command Mode INTERFACE
Usage
Information
When you set the ip ospf transmit-delay value, take into account the transmission and
propagation delays for the interface. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5
Supported
Releases
10.2.0E or later
log-adjacency-changes
Enables logging of syslog messages regarding changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
Parameters None
Default Disabled
Command Mode ROUTER-OSPF
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# log-adjacency-changes
Supported
Releases
10.2.0E or later
max-metric router-lsa
Configures OSPF to advertise a maximum metric on a router so that it is not desired as an intermediate hop from other routers.
Syntax
max-metric router-lsa
Parameters None
Default Not configured
Command Mode ROUTER-OSPF
Usage
Information
Routers in the network do not prefer other routers as the next intermediate hop after they calculate the
shortest path. The no version of this command disables the maximum metric advertisement configuration.
Example
OS10(conf-router-ospf-10)# max-metric router-lsa
Supported
Releases
10.2.0E or later
948 Layer 3