API Guide

OS10(conf-if-vn-10000)# no shutdown
OS10(conf-if-vn-10000)# exit
17. Configure externally connected VLAN.
OS10(conf)#interface vlan 200
OS10(conf-if-vlan)#ip address 10.10.0.1/16
OS10(conf-if-vlan)#no shutdown
OS10(conf-if-vlan)#exit
OS10(conf)#interface ethernet 1/1/7
switchport mode trunk
switchport trunk allowed vlan 200
18. Configure a static route for outbound traffic sent to VLAN 200.
OS10(config)#ip route 0.0.0.0/0 10.10.0.3
VTEP 4 Leaf Switch
14. Configure a dedicated VXLAN virtual network.
OS10(config)# virtual-network 500
OS10(config-vn-500)# vxlan-vni 500
OS10(config-vn-vxlan-vni)# exit
OS10(config-vn-10000)# exit
15. Configure an anycast gateway MAC address on the boder leaf VTEP. This MAC address must be different from the
anycast gateway MAC address configured on non-border-leaf VTEPs.
OS10(config)# ip virtual-router mac-address 00:02:02:02:02:02
16. Configure routing on the virtual network.
OS10(config)# interface virtual-network 500
OS10(conf-if-vn-10000)# ip vrf forwarding tenant1
OS10(conf-if-vn-10000)# ip address 10.5.0.234/16
OS10(conf-if-vn-10000)# ip virtual-router address 10.5.0.100
OS10(conf-if-vn-10000)# no shutdown
OS10(conf-if-vn-10000)# exit
17. Configure an externally connected VLAN.
OS10(conf)#interface vlan 200
OS10(conf-if-vlan)#ip address 10.10.0.2/16
OS10(conf-if-vlan)#no shutdown
OS10(conf-if-vlan)#exit
OS10(conf)#interface ethernet 1/1/7
switchport mode trunk
switchport trunk allowed vlan 200
18. Configure a static route for outbound traffic sent to VLAN 200.
OS10(config)#ip route 0.0.0.0/0 10.10.0.3
Example: VXLAN BGP EVPN—Symmetric IRB
The following VXLAN with BGP EVPN example uses a Clos leaf-spine topology to show how to set up an end-to-end VXLAN with
symmetric IRB. eBGP is used to exchange IP routes in the IP underlay network, and EVPN routes in the VXLAN overlay network. All spine
nodes are in one autonomous system—AS 101. All leaf nodes are in another autonomous system—AS 100.
• On VTEPs 1 and 2, access ports are assigned to the virtual network using a switch-scoped VLAN. EVPN for the overlay VXLAN is
configured using auto-EVI mode.
BGP EVPN for VXLAN
119