Reference Guide

Example
OS10(config)# interface null 0
OS10(conf-if-nu-0)#
Supported Releases 10.3.0E or later
interface port-channel
Creates a port-channel interface.
Syntax
interface port-channel channel-id
Parameters channel-id — Enter the port-channel ID number (1 to 128).
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the interface.
Example
OS10(config)# interface port-channel 10
OS10(conf-if-po-10)#
Supported Releases 10.2.0E or later
interface range
Congures a range of Ethernet, port-channel, or VLAN interfaces for bulk conguration.
Syntax
interface range {ethernet node/slot/port[:subport]-node/slot/port[:subport],
[...]} | {port-channel IDnumber-IDnumber,[ ...]} | vlan vlanID-vlanID,[...]}
Parameters
• node/slot/port[:subport]-node/slot/port[:subport] — Enter a range of Ethernet interfaces.
• IDnumber-IDnumber — Enter a range of port-channel numbers (1 to 128).
• vlanID-vlanID — Enter a range VLAN ID numbers (1 to 4093).
Default Not congured
Command Mode CONFIGURATION
Usage Information
Enter up to six comma-separated interface ranges without spaces between commas. When creating an interface
range, interfaces are not sorted and appear in the order entered. You cannot mix interface conguration such as
Ethernet ports with VLANs.
• Bulk conguration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk conguration with a warning message.
• This command has multiple port ranges, the smaller port range is excluded from the prompt.
• If you enter overlapping port ranges, the port range is extended to the smallest port and the largest end port.
• You can only use VLAN and port-channel interfaces created using the interface vlan and interface
port-channel commands.
• You cannot create virtual interfaces (VLAN, port-channel) using the interface range command.
• The no version of this command deletes the interface range.
Interfaces 103