Reference Guide
◦ QSFP28 unied ports operate in Ethernet 100GE mode by default, and support 2x50G, 4x25G, and
4x10G breakouts. QSFP28 ports support 4x16GFC breakouts in FC mode.
◦ SFP+ Ethernet ports operate at 10GE.
Usage Information
• Setting a port group in 2x16GFC mode activates odd-numbered interfaces 1 and 3. A port group in 1x32GFC
mode activates only interface 1.
• To display the current port prole on a switch, enter the show switch-port-profile command.
• To change the port prole on a switch, enter the switch-port-profile command with the desired prole,
save it to the startup conguration, and reload the switch. The switch reboots with new port conguration. The
no version of the command resets to the default prole. When a switch reloads with a new port prole, the
startup conguration resets to system defaults, except for the switch-port prole and these congured
settings:
– Management interface 1/1/1 conguration
– Management IPv4/IPv6 static routes
– System hostname
– Unied Forwarding Table (UFT) mode
– ECMP maximum paths
You must manually recongure other settings on a switch after you apply a new port prole and reload the
switch.
Example
OS10(config)# switch-port-profile 1/1 profile-1
Warning: Switch port profile will be applied only after a save and reload. All
management port
configurations will be retained but all other configurations will be wiped out
after the reload.
OS10(config)# do write memory
OS10(config)# do reload
Supported Releases 10.3.0E or later
switchport access vlan
Assigns access VLAN membership to a port in L2 access or trunk mode.
Syntax
switchport access vlan vlan-id
Parameters vlan vlan-id — Enter the VLAN ID number (1 to 4093).
Default VLAN 1
Command Mode INTERFACE
Usage Information This command enables L2 switching for untagged trac and assigns a port interface to default VLAN 1. Use this
command to change the assignment of the access VLAN that carries untagged trac. You must create the VLAN
before you can assign an access interface to it. The no version of this command resets access VLAN membership
on a L2 access or trunk port to VLAN 1.
Example
OS10(conf-if-eth1/1/3)# switchport mode access
OS10(conf-if-eth1/1/3)# switchport access vlan 100
Supported Releases 10.2.0E or later
116 Interfaces