Reference Guide

Switch Zoning Parameters
==========================================
Default Zone Mode: Allow
Active ZoneSet: set
==========================================
Members
fibrechannel1/1/1
fibrechannel1/1/2
fibrechannel1/1/3
fibrechannel1/1/4
fibrechannel1/1/5
fibrechannel1/1/6
fibrechannel1/1/7
fibrechannel1/1/8
fibrechannel1/1/9
fibrechannel1/1/10
fibrechannel1/1/11
fibrechannel1/1/12
fibrechannel1/1/15
fibrechannel1/1/17
fibrechannel1/1/18
fibrechannel1/1/19
fibrechannel1/1/20
fibrechannel1/1/21
fibrechannel1/1/22
fibrechannel1/1/23
fibrechannel1/1/24
fibrechannel1/1/25:1
fibrechannel1/1/29:1
fibrechannel1/1/30:1
fibrechannel1/1/30:3
==========================================
Congure vfabric in NPG mode
1 Congure a vfabric using the vfabric fabric-ID command in CONFIGURATION mode. The switch enters vfabric
CONFIGURATION mode. Enter the following commands.
2 Associate a VLAN ID to the vfabric with the vlan vlan-ID command.
3 Add FCoE parameters with the fcoe {fcmap fc-map | fcf-priority fcf-priority-value | fka-adv-period
adv-period | vlan-priority vlan-priority-value | keep-alive} command.
4 (Optional) Add a name to the vfabric using the name vfabric-name command.
5 Apply the vfabric to interfaces using the vfabric fabric-ID command in INTERFACE mode.
Example conguration of vfabric in NPG mode
OS10(config)# vfabric 10
OS10(conf-vfabric-10)# name 10
OS10(conf-vfabric-10)# vlan 100
OS10(conf-vfabric-10)# fcoe fcmap 0x0efc01
OS10(conf-vfabric-10)# fcoe fcf-priority 128
OS10(conf-vfabric-10)# fcoe fka-adv-period 8
OS10(conf-vfabric-10)# fcoe vlan-priority 3
OS10(conf-vfabric-10)# exit
OS10(config)# interface ethernet 1/1/31
OS10(conf-if-eth1/1/31)# vfabric 10
View vfabric conguration
OS10(conf-vfabric-10)# show configuration
!
vfabric 10
name 10
vlan 100
fcoe fcmap 0xEFC01
fcoe fcf-priority 128
Fibre channel
123