Reference Guide

F_Port on Ethernet
OS10 supports conguring F_Port mode on an Ethernet port that is connected to converged network adapters (CNA).
After enabling F_Port mode, congure a vfabric and apply the vfabric to Ethernet ports connected to CNA.
You can congure only one vfabric in F_Port mode.
You can apply the congured vfabric to multiple Ethernet interfaces. You can also add the Ethernet interfaces to a port-channel and apply
the vfabric to the port-channel.
Example conguration
OS10(config)# feature fc domain-id 100
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# name 100
OS10(conf-vfabric-100)# vlan 1023
OS10(conf-vfabric-100)# fcoe fcmap 0xEFC64
OS10(conf-vfabric-100)# zoneset activate set
OS10(conf-vfabric-100)# zone default-zone permit
OS10(conf-vfabric-100)# exit
OS10(config)# interface ethernet 1/1/30
OS10(conf-if-eth1/1/30)# vfabric 100
F_Port, NPG, and FCoE commands
clear fcoe database
Clears the FCoE database for the specied VLAN.
Syntax
clear fcoe database vlan vlan-id {enode enode-mac-address | fcf fcf-mac-address
| session fcoe-mac-address}
Parameters
• vlan-id — Enter the VLAN ID.
• enode-mac-address — Enter the MAC address of ENode.
• fcf-mac-address — Enter the MAC address of FCF.
• fcoe-mac-address — Enter the MAC address of FCoE session.
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# clear fcoe database vlan 100 enode aa:bb:cc:00:00:00
Supported Releases 10.4.0E(R1) or later
clear fcoe statistics
Clears FCoE statistics for specied interface.
Syntax
clear fcoe statistics [interface interface-type]
126 Fibre channel