Reference Guide

fc zoneset
Creates an FC zoneset and adds the existing FC zones to the zoneset.
Syntax
fc zoneset zoneset-name
Parameters zoneset-name — Enter a name for the FC zoneset. The name must start with a letter and may contain
characters: A-Z, a-z, 0-9, $, _, -, ^
Defaults Not congured
Command Mode CONFIGURATION
Usage Information
The no version of this command removes the FC zoneset.
Example
OS10(config)# fc zoneset set
OS10(conf-fc-zoneset-set)# member hba1
Supported Releases 10.3.1E or later
fcoe
Adds FCoE parameters to vfabric.
Syntax
fcoe {fcmap fc-map | fcf-priority fcf-priority-value | fka-adv-period adv-
period | vlan-priority vlan-priority-value | keep-alive}
Parameters — Enter the FC map ID, ranging from 0xefc00-0xefcff.
• fc-map — Enter the FC map ID, ranging from 0xefc00-0xefcff.
• fcf-priority-value — Enter the FCF priority value, ranging from 1 to 255.
• adv-period — Enter the FCF keepalive advertisement period ranging from 8 to 90 seconds.
• vlan-priority-value — Enter the VLAN priority value, ranging from 0 to 7.
Defaults
• fcmap—0x0EFC00
• fcf-priority—128
• fka-adv-period—8
• vlan-priority—3
• keep-alive—True
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command disables the FCoE parameters.
Example
OS10(config)# vfabric 10
OS10(conf-vfabric-10)# name 10
OS10(conf-vfabric-10)# fcoe fcmap 0x0efc01
OS10(conf-vfabric-10)# fcoe fcf-priority 128
OS10(conf-vfabric-10)# fcoe fka-adv-period 8
OS10(conf-vfabric-10)# fcoe vlan-priority 3
128 Fibre channel