Reference Guide

Command Mode VLAN INTERFACE
Usage Information
The no version of this command disables the FC map conguration.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
Supported Releases 10.4.0E(R1) or later
p-snooping port-mode fcf
Sets the FIP snooping port mode to FCF for interfaces.
Syntax
fip-snooping port-mode fcf
Parameters None
Defaults ENode port mode
Command Mode INTERFACE
Usage Information
By default, the port mode of an interface is set to ENode. Use this command to change the port mode to FCF. You
can set the port mode to FCF only after enabling the FIP snooping feature.
The no version of this command resets the port mode to ENode.
Example
OS10(config)# interface ethernet 1/1/32
OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf
Supported Releases 10.4.0E(R1) or later
member (alias)
Add members to existing FC aliases. Identify a member by an FC alias, a World Wide Name (WWN), or an FC ID.
Syntax
member {wwn wwn-ID | fc-id fc-id}
Parameters
• wwn-ID — Enter the WWN name.
• fc-id — Enter the FC ID name.
Defaults Not congured
Command Mode Alias CONFIGURATION
Usage Information
The no version of this command removes the member from the FC alias.
Example
OS10(config)# fc alias test
OS10(config-fc-alias-test)# member wwn 21:00:00:24:ff:7b:f5:c9
OS10(config-fc-alias-test)# member wwn 20:25:78:2b:cb:6f:65:57
Supported Releases 10.3.1E or later
Fibre channel 131