Reference Guide

vfabric
Congures a virtual fabric (vfabric). Enable the F_Port before conguring a vfabric. You can congure only one vfabric in F_Port mode. The
vfabric becomes active only when you congure the vfabric with a valid VLAN and FC map. Do not use spanned VLAN as vfabric VLAN.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information
The no version of this command removes the vfabric. You can remove a vfabric only when it is not applied on any
interfaces.
Example
OS10(config)# vfabric 100
Supported Releases 10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not congured
Command Mode INTERFACE
Usage Information
The no version of this command removes the vfabric from the FC interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
Supported Releases 10.3.1E or later
vlan
Associate an existing VLAN ID to the vfabric to carry trac. Create the VLAN ID before associating it to the vfabric. Do not use spanned
VLAN as vfabric VLAN.
Syntax
vlan vlan-ID
Parameters vlan-ID — Enter an existing VLAN ID.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command removes the VLAN ID from the vfabric.
142 Fibre channel