Reference Guide

lldp holdtime-multiplier
Congures the multiplier value for the hold time (in seconds).
Syntax
lldp holdtime-multiplier integer
Parameters integer — Enter the holdtime-multiplier value in seconds (2 to 10).
Default 4 seconds
Command Mode CONFIGURATION
Usage Information Hold time is the amount of time (in seconds) that a receiving system waits to hold the information before
discarding it. Formula: Hold Time = (Updated Frequency Interval) X (Hold Time Multiplier). The no version of this
command resets the value to the default.
Example
OS10(config)# lldp holdtime-multiplier 2
Supported Releases 10.2.0E or later
lldp med fast-start-repeat-count
Congures the number of packets sent during the activation of the fast start mechanism.
Syntax
lldp-med fast-start-repeat-count number
Parameters number — Enter the number of packets sent during the activation of the fast start mechanism (1 to 10).
Default 3
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# lldp med fast-start-repeat-count 5
Supported Releases 10.2.0E or later
lldp med
Enables or disables LLDP-MED on an interface.
Syntax
lldp med {enable | disable}
Parameters
• enable — Enable LLDP-MED on the interface.
• disable — Disable LLDP-MED on the interface.
Default Enabled with network-policy TLV
Command Mode INTERFACE
Usage Information LLDP-MED communicates the types of TLVs that the endpoint device and the network connectivity device
support. Use the no lldp med or lldp med disable command to disable LLDP-MED on a specic
interface.
Example
OS10(conf-if-eth1/1/1)# lldp med disable
Layer 2 181