Reference Guide

Default VLAN conguration
OS10# show vlan
Codes: * - Default VLAN, G-GVRP VLANs, R-Remote Port Mirroring VLANs, P-Primary, C-Community, I-
Isolated
Q: A-Access (Untagged), T-Tagged
x-Dot1x untagged, X-Dot1x tagged
G-GVRP tagged, M-Vlan-stack, H-VSN tagged
i-Internal untagged, I-Internal tagged, v-VLT untagged, V-VLT tagged
NUM Status Description Q Ports
* 1 up A Eth1/1/1-1/1/54
Create or remove VLANs
You can create VLANs and add physical interfaces or port-channel (LAG) interfaces to the VLAN as tagged or untagged members. You can
add an Ethernet interface as a trunk port or as an access port, but it cannot be added as both at the same time.
Multiple non-default vlans with physical and port channel ports in access and trunk modes
OS10# show vlan
Codes: * - Default VLAN, G-GVRP VLANs, R-Remote Port Mirroring VLANs, P-Primary, C-Community, I-
Isolated
Q: A-Access (Untagged), T-Tagged
x-Dot1x untagged, X-Dot1x tagged
G-GVRP tagged, M-Vlan-stack, H-VSN tagged
i-Internal untagged, I-Internal tagged, v-VLT untagged, V-VLT tagged
NUM Status Description Q Ports
* 1 up A Eth1/1/2 1/1/3:2 1/1/3:3 1/1/3:4 1/1/4
1/1/5 1/1/6 1/1/7 1/1/8 1/1/9 1/1/10 1/1/11 1/1/12 1/1/13 1/1/14 1/1/15 1/1/16 1/1/17 1/1/18
1/1/19 1/1/20 1/1/21 1/1/22 1/1/23 1/1/24 1/1/25:1 1/1/25:2 1/1/25:3 1/1/25:4 1/1/26 1/1/27
1/1/28 1/1/30 1/1/32
A Po40
200 up T Eth1/1/3:2
T Po40
A Eth1/1/31
320 up T Eth1/1/25:4 1/1/32
T Po40
A Eth1/1/3:1
49 1/1/50 1/1/51 1/1/52 1/1/53 1/1/54
The shutdown command stops L3 (routed) trac only. L2 trac continues to pass through the VLAN. If the VLAN is not a routed VLAN
congured with an IP address, the shutdown command has no eect on VLAN trac.
When you delete a VLAN (no interface vlan vlan-id command), any interfaces assigned to that VLAN are assigned to the
default VLAN as untagged interfaces.
Congure a port-based VLAN, enter INTERFACE-VLAN mode for VLAN related conguration tasks and create a VLAN. Assign interfaces in
L2 mode to the VLAN to enable it.
1 Create a VLAN and enter the VLAN number in INTERFACE mode (1 to 4093).
interface vlan vlan-id
2 Delete a VLAN in CONFIGURATION mode.
no interface vlan vlan-id
Create VLAN
OS10(config)# interface vlan 108
Delete VLAN
OS10(config)# no interface vlan 108
Layer 2
239