Reference Guide

Example (ERPM)
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)#
Supported Releases 10.2.0E or later
show monitor session
Displays information about a monitoring session.
Syntax
show monitor session {session-id | all}
Parameters
• session-id — Enter the session ID number (1 to 18).
• all — View all monitoring sessions.
Default All
Command Mode EXEC
Usage Information In the State eld, true indicates that the port is enabled. In the Reason eld, Is UP indicates that hardware resources are allocated .
Example (specic
session)
OS10# show monitor session 1
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
------------------------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
Example (all
sessions)
OS10# show monitor session all
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
-------------------------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
9 ethernet1/1/9 both port N/A N/A N/A N/A N/A
7 ethernet1/1/9 vlan40 both port N/A N/A N/A N/A N/A
4 ethernet1/1/1 both port N/A N/A 0 255 35006 false
Destination is not resolved
6 ethernet1/1/2 remote-ip both port 11.11.11.1 2.2.2.1 0 255 35006 false Base
session does not exist
Supported Releases 10.2.0E or later
shut
Disables the monitoring session. The monitoring session can be one of the following: local, RPM, or ERPM.
Syntax
shut
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage Information The no version of this command enables the monitoring session.
254 Layer 2