Reference Guide

Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show hash-algorithm
EcmpAlgo - crc LabAlgo - crc
Supported Releases 10.3.0E or later
IPv4 routing
OS10 supports IPv4 addressing including variable-length subnetting mask (VLSM), address resolution protocol (ARP), static routing, and
routing protocols. With VLSM, you can congure one network with dierent masks. You can also use supernetting, which increases the
number of subnets. You can add a mask to the IP address to separate the network and host portions of the IP address to add a subnet.
You need to congure IPv4 routing for IP hosts to communicate with one another in the same network, or in dierent networks.
Assign interface IP address
You can assign primary and secondary IP addresses to a physical or logical interface to enable IP communication between the system and
hosts connected to a specic interface. Assign one primary address and secondary IP addresses to each interface. By default, all ports are
in the default VLAN—VLAN 1.
1 Enter the interface type information to assign an IP address in CONFIGURATION mode.
interface interface
• ethernet—Physical interface
• port-channel—Port-channel ID number
• vlan—VLAN ID number
• loopback—Loopback interface ID
• mgmt—Management interface
2 Enable the interface in INTERFACE mode.
no shutdown
3 Remove the interface from the default VLAN in INTERFACE mode.
no switchport
4 Congure a primary IP address and mask on the interface in INTERFACE mode.
ip address ip-address mask [secondary]
• ip-address mask—Enter the IP address in dotted decimal format—A.B.C.D. and mask in slash prex-length format (/24).
•
secondary—Enter a secondary backup IP address for the interface.
Assign interface IP address to interface
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/4)# no shutdown
OS10(conf-if-eth1/1/4)# no switchport
OS10(conf-if-eth1/1/4)# ip address 10.10.1.4/8
View interface conguration
OS10# show interface ethernet 1/1/1
Ethernet 1/1/1 is up, line protocol is up
Hardware is Dell EMC Eth, address is 00:0c:29:98:1b:79
Current address is 00:0c:29:98:1b:79
Pluggable media present, QSFP-PLUS type is QSFP_40GBASE_CR4_1M
Layer 3
311