Reference Guide

clear ipv6 route
Clears routes from the IPv6 routing table.
Syntax
clear ipv6 route {* | A::B/mask}
Parameters
• *— Clears all routes and refreshes the IPv6 routing table. Trac ow for all the routes in the switch is
aected.
• A::B/mask — Removes the IPv6 route and refreshes the IPv6 routing table. Trac ow in the switch is
aected only for the specied route.
Default Not congured
Command Mode EXEC
Usage Information This command does not remove the static routes from the routing table.
Example
OS10# clear ipv6 route *
Supported Releases 10.3.0E or later
ipv6 address
Congures a global unicast IPv6 address on an interface.
Syntax
ipv6 address ipv6–address/prefix-length
Parameters ipv6-address/prex-length — Enter a full 128-bit IPv6 address with the network prex length, including the 64-bit
interface identier.
Defaults None
Command Mode INTERFACE
Usage Information
• An interface can have multiple IPv6 addresses. To congure an IPv6 address in addition to the link-local
address, enter the ipv6 address ipv6-address/mask command and specify the complete 128-bit IPv6
address. To congure a globally unique IPv6 address by entering only the network prex and length, use the
ipv6 address ipv6-prefix/prefix-length eui-64 command.
•
The no version of this command removes the IPv6 address on the interface.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/64
Supported Releases 10.3.0E or later
ipv6 address autocong
Acquires global IPv6 addresses by using the network prex obtained from router advertisements.
Syntax
ipv6 address autoconfig
Parameters None
Defaults Disabled except on the management interface
324 Layer 3