Reference Guide

Parameters number — Enter a default-metric value (1 to 16777214).
Default Not congured
Command Mode ROUTER-OSPF
Usage Information The no version of this command disables the default-metric conguration.
Example
OS10(conf-router-ospf-10)# default-metric 2000
Supported Releases 10.2.0E or later
fast-converge
Sets the minimum LSA origination and arrival times to zero (0) allowing more rapid route computation so that convergence takes less time.
Syntax
fast-converge convergence-level
Parameters convergence-level — Enter a desired convergence level value (1 to 4).
Default Not congured
Command Mode ROUTER-OSPF
Usage Information Convergence level 1 (optimal) meets most convergence requirements. Only select higher convergence levels
following consultation with Dell Technical Support. The no version of this command disables the fast-convergence
conguration.
Example
OS10(conf-router-ospf-10)# fast-converge 3
Supported Releases 10.2.0E or later
graceful-restart
Enables the helper mode during a graceful or hitless restart.
Syntax
graceful-restart role helper-only
Parameters None
Defaults Disabled
Command Mode ROUTER-OSPF
Usage Information
The no version of this command disables the helper mode.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# graceful-restart role helper-only
Supported Releases 10.3.0E or later
ip ospf area
Attaches an interface to an OSPF area.
Syntax
ip ospf process-id area area-id
Parameters
• process-id — Set an OSPF process ID for a specic OSPF process (1 to 65535)
358 Layer 3