Reference Guide

Example
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# ipv6 ospf encryption ipsec spi 500 esp des
1234567812345678 md5 12345678123456781234567812345678
OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)# ipv6 ospf encryption null
Supported Releases 10.4.0E(R1) or later
ipv6 ospf hello-interval
Sets the time interval between hello packets sent on an interface.
Syntax
ipv6 ospf hello-interval seconds
Parameters seconds — Enter the hello-interval value in seconds (1 to 65535).
Default 10 seconds
Command Mode INTERFACE
Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the
this command resets the value to the default.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30
Supported Releases 10.3.0E or later
ipv6 ospf network
Sets the network type for the interface.
Syntax
ipv6 ospf network {point-to-point | broadcast}
Parameters
• point-to-point — Sets the interface as part of a point-to-point network.
• broadcast — Sets the interface as part of a broadcast network.
Default Broadcast
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ipv6 ospf network broadcast
Supported Releases 10.3.0E or later
ipv6 ospf passive
Congures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface.
Syntax
ipv6 ospf passive
Parameters None
Default Not congured
Command Mode INTERFACE
Layer 3 391