Reference Guide
Command Mode EXEC
Usage Information This command displays OSPFv3 trac statistics for a specied instance or interface, or for all OSPFv3 instances
and interfaces.
Example
OS10# show ipv6 ospf interface ethernet 1/1/1
Interface ethernet1/1/1
Receive Statistics
rx-invalid 0 rx-invalid-bytes 0
rx-hello 0 rx-hello-bytes 0
rx-db-des 0 rx-db-des-bytes 0
rx-ls-req 0 rx-ls-req-bytes 0
rx-ls-upd 0 rx-ls-upd-bytes 0
rx-ls-ack 0 rx-ls-ack-bytes 0
Transmit Statistics
tx-hello 1054 tx-hello-bytes 37944
tx-db-des 0 tx-db-des-bytes 0
tx-ls-req 0 tx-ls-req-bytes 0
tx-ls-upd 0 tx-ls-upd-bytes 0
tx-ls-ack 0 tx-ls-ack-bytes 0
Error packets (Receive statistics)
bad-src 0 dupe-id 0 hello-err 0
mtu-mismatch 0 nbr-ignored 0
resource-err 0 bad-lsa-len 0 lsa-bad-type 0
lsa-bad-len 0 lsa-bad-cksum 0
hello-tmr-mismatch 0 dead-ivl-mismatch 0
options-mismatch 0 nbr-admin-down 0 own-hello-drop 0
self-orig 0 wrong-length 0
version-mismatch 0 area-mismatch 0
Supported Releases 10.4.0E(R1) or later
timers spf (OSPFv3)
Enables shortest path rst (SPF) throttling to delay an SPF calculation when a topology change occurs.
Syntax
timers spf [start-time [hold-time [max-wait]]]
Parameters
• start-time — Sets the initial SPF delay in milliseconds (1 to 600000; default 1000).
• hold-time — Sets the additional hold time between two SPF calculations in milliseconds (1 to 600000;
default 10000).
• max-wait — Sets the maximum wait time between two SPF calculations in milliseconds (1 to 600000;
default 10000).
Default
• start-time — 1000 milliseconds
• hold-time — 10000 milliseconds
• max-wait — 10000 milliseconds
Command Mode ROUTER-OSPFv3
Usage Information OSPFv2 and OSPFv3 support SPF throttling. By default, SPF timers are disabled in an OSPF instance.
Use SPF throttling to delay SPF calculations during periods of network instability. In an OSPF network, a topology
change event triggers an SPF calculation after a specied start time. When the start timer nishes, a hold time
may delay the next SPF calculation for an additional time. When the hold timer is running:
• Each time a topology change occurs, the SPF calculation is delayed for double the congured hold time up to
maximum wait time.
Layer 3 397