Reference Guide

Usage Information To guarantee that a VRRP group becomes master, congure the VRRP group’s virtual address with same IP
address as the interface’s primary IP address, and change the priority of the VRRP group to 255. If you set this
command to 255 and the virtual-address is not equal to the interface’s primary IP address, the system
displays an error message. The no version of this command resets the value to the default (100).
Example
OS10(conf-eth1/1/5-vrid-254)# priority 200
Supported Releases 10.2.0E or later
show vrrp
Displays VRRP group information.
Syntax
show vrrp {brief | vrrp-id | ipv6 group-id}
Parameters
• brief — Displays the conguration information for all VRRP instances in the system.
• vrrp-id — Enter a VRRP group ID number to view the VRRP IPv4 group operational status information (1 to
255).
• ipv6 group-id — (Optional) Enter a VRRP group ID number to view the specic IPv6 group operational
status information (1 to 255).
Default All IPv4 VRRP group conguration
Command Mode EXEC
Usage Information Displays all active VRRP groups. If no VRRP groups are active, the system displays “No Active VRRP group.”.
Example (Brief)
OS10 # show vrrp brief
Interface Group Priority Preemption State Master-addr Virtual addr(s)
---------------------------------------------------------------------
ethernet1/1/1 1 200 true master-state 10.1.1.1 10.1.1.1
Example (IPv6)
OS10 # show vrrp ipv6 1
Interface : ethernet1/1/1 IPv6 VRID : 1
Primary IP Address : 10::1 State : master-state
Virtual MAC Address : 00:00:5e:00:02:01
Version : version-3 Priority : 200
Preempt : Hold-time :
Authentication : no-authentication
Virtual IP address :
10::1
master-transitions : 1 advertise-rcvd : 0
advertise-interval-errors : 0 ip-ttl-errors : 0
priority-zero-pkts-rcvd : 0 priority-zero-pkts-sent : 0
invalid-type-pkts-rcvd : 0 address-list-errors : 0
pkt-length-errors : 0
Supported Releases 10.2.0E or later
track
Assigns a unique identier to track an object.
Syntax
track track-id [priority cost [value]]
Parameters
• track-id — Enter the object tracking resource ID number (1 to 500).
Layer 3 425