Reference Guide
DHCP commands
default-router address
Assigns a default gateway to clients based on the IP address pool.
Syntax
default-router address [address2...address8]
Parameters
• address — Enter an IPv4 or IPv6 address to use as the default gateway for clients on the subnet in A.B.C.D
or A::B format.
• address2...address8 — (Optional) Enter up to eight IP addresses, in order of preference.
Default Not congured
Command Mode DHCP-POOL
Usage Information Congure up to eight IP addresses, in order of preference. Use the no version of this command to remove the
conguration.
Example
OS10(conf-dhcp-20.1.1.1)# default-router 20.1.1.100
Supported Releases 10.2.0E or later
disable
Disables the DHCP server.
Syntax
disable
Parameters None
Default Disabled
Command Mode DHCP
Usage Information The no version of this command enables the DHCP server.
Example
OS10(conf-dhcp)# no disable
Supported Releases 10.2.0E or later
dns-server address
Assigns a DNS server to clients based on the address pool.
Syntax
dns-server address [address2...address8]
Parameters
• address — Enter the DNS server IP address that services clients on the subnet in A.B.C.D or A::B format.
• address2...address8 — (Optional) Enter up to eight DNS server addresses, in order of preference.
Default Not congured
438 System management