Reference Guide

Telnet server
To allow Telnet TCP/IP connections to an OS10 switch, enable the Telnet server. The OS10 Telnet server uses the Debian telnetd
package. By default, the Telnet server is disabled.
When the Telnet server is enabled, connect to the switch using the IP address congured on the management or any front-panel port. The
Telnet server conguration is persistent and is maintained after you reload the switch. To verify the Telnet server conguration, enter the
show running-configuration command.
Enable Telnet server
OS10(config)# ip telnet server enable
Disable Telnet server
OS10(config)# no ip telnet server enable
By default, the Telnet server is disabled on the default VRF. To congure the Telnet server to be reachable on the management VRF, use
the ip telnet server vrf management command.
Congure Telnet server on management VRF
OS10(config)# ip telnet server vrf management
Telnet commands
ip telnet server enable
Enables Telnet TCP/IP connections to an OS10 switch.
Syntax
ip telnet server enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage Information By default, the Telnet server is disabled. When you enable the Telnet server, use the IP address congured on the
management or any front-panel port to connect to an OS10 switch. After you reload the switch, the Telnet server
conguration is maintained. To verify the Telnet server conguration, enter the show running-
configuration command.
Example
OS10(config)# ip telnet server enable
Example (disable)
OS10(config)# no ip telnet server enable
Supported Releases 10.3.1E or later
ip telnet server vrf
Congures the Telnet server for the management VRF instance.
Syntax
ip telnet server vrf management
456 System management