Reference Guide

Example
OS10(config)# password-attributes min-length 6 character-restriction upper 2
lower 2 numeric 2
Supported Releases 10.4.0E(R1) or later
radius-server host
Congures a RADIUS authentication server.
Syntax
radius-server host {hostname | ip-address} [auth-port port-number | key
authentication-key]
Parameters
• hostname — Enter the host name of the RADIUS server.
• ip-address — Enter the IPv4 (A.B.C.D) or IPv6 (x:x:x:x::x) address of the RADIUS server.
• auth-port port-number — (Optional) Enter the UDP port number used on the server for authentication
(0 to 65535, default 1812)
• key authentication-key — (Optional) Enter the authentication key used to authenticate the switch on
the server (up to 42 characters; default radius_secure).
Default Not congured
Command Mode CONFIGURATION
Usage Information The authentication key must match the key congured on the RADIUS server. Congure global settings for the
timeout and retransmit attempts allowed on RADIUS servers by using the radius-server retransmit and
radius-server timeout commands. The no version of this command removes a RADIUS server
conguration.
Example
OS10(config)# radius-server host 1.5.6.4 key secret1
Supported Releases 10.2.0E or later
radius-server retransmit
Congures the number of authentication attempts allowed on RADIUS servers.
Syntax
radius-server retransmit retries
Parameters retries — Enter the number of retry attempts (0 to 100).
Default An OS10 switch retransmits a RADIUS authentication request three times.
Command Mode CONFIGURATION
Usage Information Use this command to globally congure the number of retransmit attempts allowed for authentication requests on
RADIUS servers. The no version of this command resets the value to the default.
Example
OS10(config)# radius-server retransmit 50
Supported Releases 10.2.0E or later
470 System management