Reference Guide

Usage Information This command manually brings up a disabled downstream interface that is in UFD-disabled error state. After the
downstream interface is up, it is not disabled until there are changes in the upstream interfaces. This command
does not have eect on downstream interfaces that are already up or interfaces that are not part of the UFD
group.
Example
OS10# clear ufd-disable interface ethernet 1/1/2
OS10# clear ufd-disable uplink-state-group 1
Supported Releases 10.4.0E(R3) or later
downstream
Adds an interface or a range of interfaces as a downstream interface to the uplink-state group.
Syntax
downstream {interface-type | interface-range}
Parameters
• interface-type — Enter the interface type as Ethernet or port-channel.
• interface-range — Enter the range of interfaces.
Default None
Command Mode UPLINK-STATE-GROUP
Usage Information You cannot assign an interface that is already a member of an uplink-state group to another group. The no version
of this command removes the interface from the uplink-state group.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# downstream ethernet 1/1/1
Supported Releases 10.4.0E(R3) or later
enable
Enables tracking of an uplink-state group.
Syntax
enable
Parameters None
Default Disabled
Command Mode UPLINK-STATE-GROUP
Usage Information The no version of this command disables tracking of an uplink-state group.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# enable
Supported Releases 10.4.0E(R3) or later
name
Congures a descriptive name for the uplink-state group.
Syntax
name string
System management 479