Reference Guide

View monitor sessions
OS10(conf-if-eth1/1/1)# show monitor session all
S.Id Source Destination Dir SrcIP DstIP DSCP TTL State Reason
----------------------------------------------------------------------------
1 ethernet1/1/1 ethernet1/1/4 both N/A N/A N/A N/A true Is UP
ACL commands
clear ip access-list counters
Clears ACL counters for a specic access-list.
Syntax
clear ip access-list counters [access-list-name]
Parameters access-list-name — (Optional) Enter the name of the IP access-list to clear counters. A maximum of 140
characters.
Default Not congured
Command Mode EXEC
Usage Information If you do not enter an access-list name, all IPv6 access-list counters clear. The counter counts the number of
packets that match each permit or deny statement in an access-list. To get a more recent count of packets
matching an access list, clear the counters to start at zero. To view access-list information, use the show
access-lists command.
Example
OS10# clear ip access-list counters
Supported Releases 10.2.0E or later
clear ipv6 access-list counters
Clears IPv6 access-list counters for a specic access-list.
Syntax
clear ipv6 access-list counters [access-list-name]
Parameters access-list-name — (Optional) Enter the name of the IPv6 access-list to clear counters. A maximum of 140
characters.
Default Not congured
Command Mode EXEC
Usage Information If you do not enter an access-list name, all IP access-list counters clear. The counter counts the number of packets
that match each permit or deny statement in an access list. To get a more recent count of packets matching an
access list, clear the counters to start at zero. To view access-list information, use the show access-lists
command.
Example
OS10# clear ipv6 access-list counters
Supported Releases 10.2.0E or later
Access Control Lists 499