Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4112F-ON/S4112T-ON

511

512

513

514

515

516

517

518

519

520

• A.B.C.D — Enter the IP address in dotted decimal format.

• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.

• any — (Optional) Set all routes which are subject to the lter:

– capture — (Optional) Capture packets the lter processes.

– count — (Optional) Count packets the lter processes.

– byte — (Optional) Count bytes the lter processes.

– dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.

– fragment — (Optional) Use ACLs to control packet fragments.

• host ip-address — (Optional) Enter the IP address to use a host address only.

Default Not congured

Command Mode IPV4-ACL

Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The

no version of this command removes the lter.

Example

OS10(config)# ip access-list testflow

OS10(conf-ipv4-acl)# permit udp any any capture session 1

Supported Releases 10.2.0E or later

permit (IPv6)

Congures a lter to allow packets with a specic IPv6 address.

Syntax

permit [protocol-number | icmp | ipv6 | tcp | udp] [A::B | A::B/x | any | host

ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | count [byte]

| dscp value | fragment]

Parameters

• protocol-number — (Optional) Enter the protocol number identied in the IPv6 header, from 0 to 255.

• icmp — (Optional) Enter the ICMP address to permit.

• ipv6 — (Optional) Enter the IPv6 address to permit.

• tcp — (Optional) Enter the TCP address to permit.

• udp — (Optional) Enter the UDP address to permit.

• A::B — Enter the IPv6 address in hexadecimal format separated by colons.

• A::B/x — Enter the number of bits that must match the IPv6 address.