Reference Guide
Default Not congured
Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter, or use the no seq sequence-number command if you know
the lter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 5 deny ipv6 any any capture session 1 count
Supported Releases 10.2.0E or later
seq deny (MAC)
Assigns a sequence number to a deny lter in a MAC access list while creating the lter.
Syntax
seq sequence-number deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos
| count [byte] | vlan]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• nn:nn:nn:nn:nn:nn — Enter the source MAC address.
• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of 00:00:00:00:00:00 applies.
• any — (Optional) Set all routes which are subject to the lter:
– protocol-number — Protocol number identied in the MAC header, from 600 to .
– capture — (Optional) Capture packets the lter processes.
– cos — (Optional) CoS value, from 0 to 7.
– count — (Optional) Count packets the lter processes.
– byte — (Optional) Count bytes the lter processes.
– vlan — (Optional) VLAN number, from 1 to 4093.
Default Not congured
Command Mode CONFIG-MAC-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter, or use the no seq sequence-number command if you know
the lter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2
Supported Releases 10.2.0E or later
Access Control Lists 527