Reference Guide

Example (range)
OS10(config)# vlt-domain 2
OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12
Supported Releases 10.2.0E or later
peer-routing
Enables or disables L3 routing to peers.
Syntax
peer-routing
Parameters None
Default Disabled
Command Mode VLT-DOMAIN
Usage Information The no version of this command disables L3 routing.
Example
OS10(conf-vlt-1)# peer-routing
Supported Releases 10.2.0E or later
peer-routing-timeout
Congures the delay after which peer routing is disabled when the peer is not available. This command is applicable for both IPv6 and IPv4.
Syntax
peer-routing-timeout value
Parameters value — Enter the timeout value in seconds, from 0 to 65535.
Default 0
Command Mode VLT-DOMAIN
Usage Information
Use this command to congure a timer to disable the peer-routing when the peer is not available. When the timer
expires, the software checks to see if the VLT peer is available. If the VLT peer is not available, peer-routing is
disabled on the peer. If you do not congure the timer, peer-routing is not disabled even when the peer is
unavailable.
Example
OS10(conf-vlt-1)# peer-routing-timeout 120
Supported Releases 10.3.0E or later
show spanning-tree virtual-interface
Displays details of STP and RPVST+ information specic to VLT.
Syntax
show spanning-tree virtual-interface [detail]
Parameters detail — (Optional) Displays detailed output.
Default Not congured
Command Mode EXEC
Virtual link trunking 621