Reference Guide
After you enter enable auto-breakout and plug a breakout cable in Ethernet port 1/1/25:
OS10# show interface status
------------------------------------------------------------------
Port Description Status Speed Duplex Mode Vlan Tagged-Vlans
------------------------------------------------------------------
Eth 1/1/1 down 0 auto -
Eth 1/1/2 down 0 auto A 1 -
Eth 1/1/25:1 down 0 auto A 1 -
Eth 1/1/25:2 down 0 auto A 1 -
Eth 1/1/25:3 down 0 auto A 1 -
Eth 1/1/25:4 down 0 auto A 1 -
Eth 1/1/29 down 0 auto A 1 -
Reset default conguration
You can clear all congured settings on an Ethernet or Fibre Channel interface and reset the interface to its default settings. By default:
• An Ethernet interface is enabled (no shutdown) and assigned to the default VLAN. An Ethernet interface has no IP address and no
L2 switchport is congured (no IP address).
• A Fibre Channel interface is disabled (shutdown).
Restrictions
The default interface command removes all software settings and all L3, VLAN, VXLAN, and port-channel congurations on a port
interface. However, the command does not remove congurations to the interface from other software features, such as VLT. If you do not
remove these congured settings, the command does not execute. For example, if an Ethernet interface is congured as a discovery
interface in a VLT domain and you do not delete this setting, resetting the interface to its default conguration fails:
OS10(config)# vlt-domain 10
OS10(conf-vlt-10)# discovery-interface ethernet 1/1/1
OS10(conf-vlt-10)# exit
OS10(config)# default interface ethernet 1/1/1
Proceed to cleanup the interface config? [confirm yes/no]:y
% Error: Discovery Interface mode must not be in switchport mode
Conguration
1 From CONFIGURATION mode, enter INTERFACE mode and view the currently congured settings.
interface {ethernet | fibrechannel} node/slot/port[:subport]
show config
2 Return to CONFIGURATION mode.
exit
3 Reset an interface to its default conguration in CONFIGURATION mode. Enter multiple interfaces in a comma-separated string or a
port range using the default interface range command.
default interface {ethernet | fibrechannel} node/slot/port[:subport]
4 Enter INTERFACE mode and verify the factory-default conguration.
interface {ethernet | fibrechannel} node/slot/port[:subport]
show config
Reset default Ethernet conguration
OS10(conf-if-eth1/1/2)# show configuration
!
interface ethernet 1/1/2
no shutdown
no switchport
negotiation on
ip address 1.2.3.4/24
ip address 2.2.2.2/24 secondary
ip address 3.3.3.3/24 secondary
ipv6 address 10::1/64
Interfaces
87