Users Guide

Table Of Contents
Parameters
sequence-number Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
nn:nn:nn:nn:nn:nn Enter the source MAC address.
00:00:00:00:00:00 (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
any (Optional) Set all routes which are subject to the filter:
protocol-number Protocol number identified in the MAC header, from 600 to ffff.
capture (Optional) Capture packets the filter processes.
cos (Optional) CoS value, from 0 to 7.
count (Optional) Count packets the filter processes.
byte (Optional) Count bytes the filter processes.
vlan (Optional) VLAN number, from 1 to 4093.
Default Not configured
Command Mode CONFIG-MAC-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter, or use the no seq sequence-number
command if you know the filters sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any
cos 7
OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any
vlan 2
Supported
Releases
10.2.0E or later
seq deny icmp
Assigns a filter to deny ICMP messages while creating the filter.
Syntax
seq sequence-number deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count | dscp value
| fragment | log]
Parameters
sequence-number Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
A.B.C.D Enter the IPv4 address in dotted decimal format.
A.B.C.D/x Enter the number of bits that must match the dotted decimal address.
any (Optional) Enter the keyword any to specify any source or destination IP address.
host ip-address (Optional) Enter the IPv4 address to use a host IP address only.
capture (Optional) Capture packets the filter processes.
count (Optional) Count packets the filter processes.
byte (Optional) Count bytes the filter processes.
dscp value (Optional) Deny a packet based on the DSCP values, from 0 to 63.
fragment (Optional) Use ACLs to control packet fragments.
log (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter, or use the no seq sequence-number
command if you know the filters sequence number.
Access Control Lists 1147