Users Guide

Default Not configured
Command Mode ROUTE-MAP
Usage
Information
The no version of this command deletes the match.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# match ipv6 address test100
Supported
Releases
10.3.0E or later
match ipv6 next-hop
Configures a filter to match based on the next-hop IPv6 addresses specified in IP prefix lists.
Syntax
match ipv6 next-hop prefix-list prefix-list
Parameters prefix-list — Enter the name of the configured prefix list. A maximum of 140 characters.
Default Not configured
Command Mode ROUTE-MAP
Usage
Information
The no version of this command deletes the match.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# match ipv6 next-hop prefix-list test100
Supported
Releases
10.3.0E or later
match metric
Configures a filter to match on a specific value.
Syntax
match metric metric-value
Parameters metric-value — Enter a value to match the route metric against, from 0 to 4294967295.
Default Not configured
Command Mode ROUTE-MAP
Usage
Information
The no version of this command deletes the match.
Example
OS10(conf-route-map)# match metric 429132
Supported
Releases
10.2.0E or later
match origin
Configures a filter to match routes based on the origin attribute of BGP.
Syntax
match origin {egp | igp | incomplete}
Parameters
● egp — Match only remote EGP routes.
● igp — Match only on local IGP routes.
● incomplete — Match on unknown routes that are learned through some other means.
Access Control Lists 1171