Users Guide

View information for a single interface:
OS10# show qos port-map details interface ethernet 1/1/1
---------------------------------------------------------------------------
Interface Port Pipe Ingress MMU Egress MMU Oper Status
---------------------------------------------------------------------------
Eth 1/1/1 3 0, 1 1, 3 down
QoS commands
bandwidth
Assigns a percentage of weight to the queue.
Syntax
bandwidth percent value
Parameters percent value — Enter the percentage assignment of bandwidth to the queue, from 1 to 100.
Default Not configured
Command Mode POLICY-MAP CLASS-MAP
Usage
Information
If you configure this command, you cannot use the priority command for the class.
Example
OS10(config-pmap-c-que)# bandwidth percent 70
Supported
Releases
10.2.0E or later
buffer-statistics-tracking
Enables or disables buffer statistics tracking feature globally.
Syntax
buffer-statistics-tracking
Parameters None
Default Disabled
Command Mode SYSTEM-QOS
Usage
Information
The no form of the command disables buffer statistics tracking feature globally. After you disable
BST, be sure to clear the counter using the clear qos statistics type buffer-statistics-
tracking command.
Example
OS10# configure terminal
OS10(config)# system qos
OS10(config-sys-qos)# buffer-statistics-tracking
Supported
Releases
10.4.3.0 or later
class
Creates a QoS class for a type of policy-map.
Syntax
class class—name
Parameters class-name — Enter a name for the class-map. A maximum of 32 characters.
1220 Quality of service