Users Guide

Table 48. Port groups and breakout modes on the S5296F-ON switch
Port Group Ports Supported breakout modes
● 50g-2x
● 40g-1x
● 25g-4x
● 10g-4x
Port-group1/1/29 101
● 100g-1x
● 50g-2x
● 40g-1x
● 25g-4x
● 10g-4x
Port-group1/1/30 102
● 100g-1x
● 50g-2x
● 40g-1x
● 25g-4x
● 10g-4x
Port-group1/1/31 103
● 100g-1x
● 50g-2x
● 40g-1x
● 25g-4x
● 10g-4x
Port-group1/1/32 104
● 100g-1x
● 50g-2x
● 40g-1x
● 25g-4x
● 10g-4x
To configure breakout modes:
1. Configure a port group in CONFIGURATION mode. Enter 1/1 for node/slot and the port group number.
port-group node/slot/port-group
2. Configure the breakout mode in PORT-GROUP mode.
mode Eth breakout-mode
● 100g-2x — Split a port group into two 100GE interface.
● 100g-1x — Set a port group to 100GE mode.
● 50g-4x — Split a port group into four 50GE interfaces.
● 50g-2x — Split a port group into two 50GE interfaces.
● 40g-2x — Split a port group into two 40GE interfaces for use with a QSFP+ 40GE transceiver.
● 40g-1x — Set a port group to 40GE mode for use with a QSFP+ 40GE transceiver.
● 25g-8x — Split a port group into eight 25GE interfaces.
● 25g-4x — Split a port group into four 25GE interfaces.
● 10g-8x — Split a port group into eight 10GE interfaces.
● 10g-4x — Split a port group into four 10GE interfaces.
3. Return to CONFIGURATION mode.
exit
4. Enter Interface breakout mode to configure other settings, such as, speed.
interface ethernet node/slot/port[:subport]
Interfaces
251