Users Guide

clear fcoe statistics
Clears FCoE statistics for specified interface.
Syntax
clear fcoe statistics [interface interface-type]
Parameters interface-type — (Optional) Enter the interface type. The interface may be ethernet, VLAN, or
port-channel.
Default Not configured
Command Mode EXEC
Usage
Information
If you do not specify the interface interface-type information, the command clears the statistics
for all the interfaces and VLANs.
Example
OS10# clear fcoe statistics interface ethernet 1/1/1
OS10# clear fcoe statistics interface port-channel 5
Supported
Releases
10.4.0E(R1) or later
fcoe-pinned-port
Marks a port as a pinned port in the port-channel. This configuration is supported on FSB, Ethernet LAG in NPG, and F_Port
mode. It is not supported on a VLTi LAG.
Syntax
fcoe-pinned-port
Parameters node/slot/port[:subport]—Enter the interface type details.
Defaults Disabled
Command Mode Port-channel INTERFACE
Usage
Information
You can configure only single port per port-channel. If the port is not configured properly, or if the pinned
port goes down, the other ports in the port-channel are not used even if the ports have valid path to
server. The no version of this command removes the pinned port configuration.
Example
OS10(conf-if-eth-1/1/9)# channel-member 10
OS10(conf-if-eth-1/1/9)# fcoe-pinned-port
Warning: Any existing FCoE session in port-channel will get cleared. Do
you want to continue(yes/no)?yes
Supported
Releases
10.4.2.0 or later
fcoe max-sessions-per-enodemac
Configures the maximum number of sessions allowed for an ENode.
Syntax
fcoe max-sessions-per-enodemac max-session-number
Parameters max-session-number — Enter the maximum number of sessions to be allowed, from 1 to 64.
Defaults 32
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the number of sessions to the default value.
NOTE: This command is not available in the fabric mode of MX9116N-ON. So in MX9116N-ON, the
number of FCoE sessions is always 32. If the device is in Full-switch mode, you can configure the
390 Fibre Channel