Users Guide

Table Of Contents
Example
OS10(conf-mst)# name my-mst-region
Supported
Releases
10.2.0E or later
revision
Configures a revision number for the MSTP configuration.
Syntax
revision number
Parameters number Enter a revision number for the MSTP configuration, from 0 to 65535.
Default 0
Command Mode MULTIPLE-SPANNING-TREE
Usage
Information
To have a bridge in the same MST region as another, the default values for the revision number must
match on all Dell EMC hardware devices. If there are non-Dell EMC devices, ensure the revision number
value matches on all the devices. For more information, see Non-Dell Hardware.
Example
OS10(conf-mst)# revision 10
Supported
Releases
10.2.0E or later
spanning-tree mst
Configures an MST instance and determines root and bridge priorities.
Syntax
spanning-tree mst instance number priority | root {primary | secondary}
Parameters
instance number Enter an MST instance number, from 0 to 63. For Z9332F-ON platform,
enter a MST instance value from 0 to 61.
priority priority value Set a bridge priority value in increments of 4096, from 0 to 61440.
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768, 36864, 40960,
45056, 49152, 53248, 57344, and 61440. All other values are rejected.
root Enter a primary or secondary root.
primary Enter a device as a primary root.
secondary Enter a device as a secondary root.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The MSTP determines the root bridge but you can assign one bridge a lower priority to increase the
probability it being the root bridge. A lower priority-value increases the probability of the bridge
becoming a root bridge. The no version of this command resets the value to the default.
Example
OS10(config)# spanning-tree mst 0 priority 0
OS10(config)# spanning-tree mst 2 root primary
Supported
Releases
10.2.0E or later
spanning-tree msti
Configures the MSTI, cost, and priority values for an interface.
Syntax
spanning-tree msti instance {cost cost | priority value}
Layer 2 501