Users Guide

Default Disabled
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command disables the flow-based monitoring.
Example
OS10(conf-mon-local-1)# flow-based enable
OS10(conf-mon-rpm-source-2)# flow-based enable
OS10(conf-mon-erpm-source-3)# flow-based enable
Supported
Releases
10.2.0E or later
ip
Configures the IP time-to-live (TTL) value and the differentiated services code point (DSCP) value for the ERPM traffic.
Syntax
ip {ttl ttl-number | dscp dscp-number}
Parameters
● ttl-number—Enter the TTL value, from 1 to 255.
● dscp-number—Enter the DSCP value, from 0 to 63.
Default
● TTL: 255
● DSCP: 0
Command Mode MONITOR-SESSION (ERPM)
Usage
Information
The no version of this command removes the configured TTL and DSCP values.
Example
OS10(conf-mon-erpm-source-10)# ip ttl 16
OS10(conf-mon-erpm-source-10)# ip DSCP 63
Supported
Releases
10.4.0E(R1) or later
monitor session
Creates a session for monitoring traffic with port monitoring.
Syntax
monitor session session-id type [local | rpm-source | erpm-source]
Parameters
● session-id—Enter a monitor session ID, from 1 to 18.
● local—(Optional) Enter a local monitoring session.
● rpm-source—(Optional) Enter a remote monitoring session.
● erpm-source—(Optional) Enter an encapsulated remote monitoring session.
Default local
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the monitor session.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)#
Layer 2 523